Separates gold from gangue by density difference. Suitable for liberated coarse gold (ideally >0.5mm), placer gold, and recovery of coarse gold in the grinding circuit.
Core equipment: Jaw crusher → Cone crusher/roll crusher → Ball mill + classifier → Knelson centrifugal concentrator (primary) → Shaking table (cleaning)
Key point: Few equipment items, low entry barrier—but nearly powerless against micro-fine gold. In one micro-fine gold ore test, Knelson recovery was only 5%–10%. Whether gravity can serve as the main process depends on the coarse-gold proportion shown by process mineralogy.
Suitable for gold ores with high sulfide content, where gold is finely disseminated in carriers such as pyrite or arsenopyrite, or where multi-metal recovery is required.
Core equipment: Ball mill + hydrocyclone → Jameson flotation cell (roughing/cleaning) + mechanical flotation cells (scavenging) → Thickener + filter press
Key point: Combining Jameson with conventional flotation cells reduces investment and footprint. Flotation only produces gold concentrate—it cannot produce gold directly. A downstream cyanidation, roasting, or smelting unit must follow; it cannot be omitted from the equipment list.
Suitable for oxide ores, clay-rich ores, and reprocessing of flotation/gravity concentrates and tailings. Whole-ore cyanidation with carbon-in-leach (CIL) can achieve over 90% recovery.
Core equipment: Two/three-stage crushing → Ball mill + classifier → Leach tanks (air-agitated) + activated carbon → Elution and electrowinning system → Thickener + filter → Tailings filter press + cyanide destruction system → Smelting furnace
Key point: Highest investment and operating cost of the three. Environmental equipment is mandatory, not optional. For small throughput plants, fixed costs are hard to amortize, and economics often compare unfavorably with gravity or flotation.
| Dimension | Gravity Separation | Flotation | Cyanidation (CIL) |
|---|---|---|---|
| Applicable gold size | Coarse (>0.5mm preferred) | Fine, disseminated in sulfides | Free state, oxide ores, concentrates/tailings |
| Core equipment | Knelson + shaking table | Jameson + mechanical cells | Leach tanks + elution/electrowinning + cyanide destruction |
| Equipment chain | Short | Medium | Long |
| Investment threshold | Low | Medium | High |
| Typical recovery | 20–60% for coarse gold | 80–87% (in concentrate) | 90–93% |
| Main limitation | Cannot recover fine gold | Cannot produce gold directly | Environmental pressure; As/C/Cu ores need pretreatment |
The three processes are often used in combination: gravity + cyanidation (recover coarse gold in grinding circuit, tailings to cyanidation), flotation + cyanidation (concentrate re-leached), gravity + flotation (recover coarse gold first, then float sulfides).
Equipment configuration must be based on process mineralogy analysis + comparative beneficiation tests. A one-order-of-magnitude difference in gold particle size can mean a completely different equipment list—test costs are far lower than the cost of retrofitting after choosing the wrong equipment.